Safety Standards Certificate: How to Get Approved?

Giving or getting a vehicle isn’t a day to day acquisition or purchase. A vehicle posts a significant investment or asset that can be beneficial if you make the right choice. The top concern we all have in mind is that the car we drive is safe. If a vehicle is safe, it means it is in good working condition. But how can you determine this?

The Ontario Ministry of Transportation demands to get a certification. This requirement is specifically known as the Safety Standards Certificate (SSC). It is only acquired when your vehicle is proven to meet the minimum safety standards. An SSC will authorize you to put a new plate on it.

As stated on their website, if you register a rebuilt vehicle, one that came from another territory or country, transferring, or changing its status, you need an SSC. Regarding where to get a safety standards certificate, it is at any MTO licensed inspection station. Your certificate will be valid for 36 days, so you want to get your car registered during that time, or you will have to get a new one when the deadline is up.

Get It Right: Recommendations to Obtain Your Safety Standards Certificate.

The process of getting a safety standards certificate seems very straightforward. You select your nearest MTO licensed station, and you get your vehicle inspected and get approved. But what happens if your car gets denied its certification?

When this happens, you have to get any issues repaired to get a plate and use the vehicle question. However, the safety standards certificate’s cost varies according to the inspection stations since the legislation doesn’t regulate it.

Think about it, your safety and everybody’s safety is a priority. Anything you can do to protect it is worth it. Still, owning or selling your vehicle is also urgent for you. We understand you want to expedite this process while complying with the norms.

To do so, you can follow our recommendation as experienced car repair and inspection specialists to increase your possibilities of getting your safety standards certificate:

Look For Any Issues Beforehand

Excluding a rebuilt vehicle, if you have a used car, it doesn’t mean you have to redo it to get your certificate. We share a brief walkthrough of some of your vehicle’s elements to keep an eye on to avoid getting turned down in an SSC inspection:

Brake System: In a used car, it is common for some components to be worn out, and you might be OK with that. However, when it comes to the brake system, too much wear can be a risk. You might want to fix any major problems with your brake system (drums, brake fluid, etc.)
Tires & Steering System: Again, you use your tires and steering wheel a lot. Naturally, they will get worn out. Take time to check your tires and steering wheel’s condition. Other key components that usually get inspected are power steering fluid, pump, and alignment.
Engine: Needless to say, you have to pay attention to your vehicle’s engine. It goes from oil and filters up to the starter, mounts, and overall functionality.
Suspension: Without suspension, there is no mobility. All different suspension components such as shock absorbers, stabilizers, chassis must be in good working condition.
Exhaust System: You wouldn’t want to breathe exhaust gases inside your vehicle, right? And with all due reason, because it would be a major safety hazard. Checking your exhaust system is essential, including the muffler, pipes, and emissions. It would be best if you addressed anything too risky.

Opting to do a brief revision of your vehicle can give you more certainty to get your Safety Standards Certificate. However, you can’t always rely on a superficial one. A thorough safety inspection is still more dependable.

Get a Safety Inspection + Repair.

Now you may be wondering, isn’t a safety inspection and a safety standards certificate inspection the same? The answer is, they are not. Still, they follow the same principle, which is ensuring your vehicle is safe to drive.

Getting a professional safety inspection can help solve any issues that might prevent you from obtaining your Safety Standards Certificate. You can find this service at some auto repair shops, which means you can also get any detected issues repaired. It may look like an extra hassle, but you will be more confident that you will get your SSC and not have to pay for it again.

Here at Amarz Auto Service, we execute reliable safety inspections in Brampton, Etobicoke, Mississauga, and Toronto. If you want more assistance on the topic, you can contact us or visit our nearest shop!